Kwikset Door Handle Allen Wrench

If you remove the lever and on one side of the shaft there is a hole and the other side there is a silver button.

Kwikset door handle allen wrench.

Use an allen wrench to remove the lever. Remove the screw and slip the lever handle off the rod. Determine whether you will need an allen wrench or a screwdriver based on the style of set screw which you will find on the bottom of the door lever. It comes with a 1 16 inch allen wrench to tighten it.

It worked just fine with a tight fit. This model is a lever and requires a 3 32 allen wrench to remove the handle in order to pop the rose plate off and expose the screws. Look for these fasteners along the base of the lever then use an allen wrench that fits snugly into the head of the fastener. Whether you like the sleek clean look of contemporary decor or the delicate curves of traditional hardware kwikset offers many styles and finishes so you can have the look you want while maintaining certified security.

Turn the wrench to remove the fastener then pull the lever away from the door by hand. This model is a lever and requires a 3 32 allen wrench to remove the handle in order to pop the rose plate off and expose the screws. Move the hex wrench around until it connects with the hex head of the set screw that has to be screwed out of the opposite side of the post to connect to the inside of the lever to hold it securely. Take a 3 32 hex wrench kwikset provides one with the lock stick it through the hole in the lever to the inside of the lock.

The set screws appear to be size 5 40 x 3 16 inch long right hand thread. Some lever handles have hexagonal shaped fasteners that require an allen wrench for removal. Handlesets handlesets can elevate the entry of your home and create a warm welcome for all who come to your door. Step 2 inspect the rod s surface and locate the groove where the set screw needs to be secured.

This fit my kwikset lever lock handle. That silver button is the set screw. If you are experiencing the lever falling off the set screw is still in the shaft. Which is what you want so it will not back out easily.